
DIGI-P122 / DIGI-P123 Installation Guide
RCA/3.5mm Input Signal Level
RCA/3.5mm Input Impedance
-48dB Nominal (Mic input), +4dBu Nominal (Line Input)
600 ohm (Mic input), >10k ohm (Line input)
Line Level Output Impedance
2x10W @ 8ohm / 2x20W @ 4ohm
Stereo Channel Separation
HDBaseT Signal Characteristics
Solid core shielded Category 5e, Category 6 or greater with TIA/EIA-568B
crimp pattern
Signal to Noise Ratio (SNR)
> 70 dB at 100 MHz over 100 m
Total Harmonic Distortion (THD)
±10° at 135 MHz over 100 m
Chassis and Environmental
483 mm x 235 mm x 44 mm (19 in x 9.25 in x 1.73 in) – 1RU
0° to +48° C (+32° to +120° F)
10% to 90%, Non-condensing
-20° to +70° C (+14° to +158° F)
10% to 85%, Non-condensing
Maximum Power Consumption
IR Remote, Power Cable, Four (4) Rubber Feet, Serial Cable (DE9-F to
Euroblock), Operation Guide
Compatible Receivers (A/V Only)
Compatible Receivers (A/V and RS232)
DIGI-HDE-R, DIGI-HD60C-R, FLX-BI4
*Requires Compatible HDBaseT Receiver
**VGA Output will turn off when encrypted content is selected.
Distances and picture quality may be affected by cable grade, cable quality, source and destination equipment, RF and electrical interference, and cable patches.
26
Comentarios a estos manuales